Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drafting Standards, GD&T & Tolerance Analysis

hodgsont
  • Locked
  • Question Question
Section view created from another section view?
Replies
7
Views
453
hodgsont
hodgsont
Cig
  • Locked
  • Question Question
Rivet Callout
Replies
7
Views
2K
Cig
Cig
mohinderlamba
  • Locked
  • Question Question
Newbie to Drafting
2
Replies
35
Views
902
nadam35
nadam35
leung2005
  • Locked
  • Question Question
Flatness requirement and callout questions
Replies
8
Views
844
drawoh
drawoh
JoeBlock
  • Locked
  • Question Question
Best way to tolerence machined hole to center of boss?
2
Replies
27
Views
1K
ewh
ewh
Tunalover
  • Locked
  • Question Question
Spacer problem
Replies
9
Views
328
MikeHalloran
MikeHalloran
092961
  • Locked
  • Question Question
Part Quantities When Using "Stacked" Balloons
Replies
10
Views
846
drawoh
drawoh
palecactus
  • Locked
  • Question Question
drafting methods
2
Replies
34
Views
771
KENAT
KENAT
KENAT
  • Locked
  • Question Question
Is dimensioning/detailing in isometric view acceptable??
2
Replies
24
Views
2K
ewh
ewh
v5newto
  • Locked
  • Question Question
How do you create a frame and title block for reuse?
Replies
1
Views
145
ewh
ewh
Randy1111
  • Locked
  • Question Question
Concentricity vs Runout
Replies
14
Views
957
aardvarkdw
aardvarkdw
wes616
  • Locked
  • Question Question
Flatness in assy
2
Replies
24
Views
1K
CheckerRon
CheckerRon
wes616
  • Locked
  • Question Question
Ellipses
Replies
9
Views
1K
MechNorth
MechNorth
geoffthehammer
  • Locked
  • Question Question
Tolerancing problem
Replies
1
Views
173
MechNorth
MechNorth
Tunalover
  • Locked
  • Question Question
Assigning a datum axis through a tapered (countersunk) holes
Replies
12
Views
582
MechNorth
MechNorth
KENAT
  • Locked
  • Question Question
Assembly Drawings - Or Instruction manuals
2 3
Replies
44
Views
2K
KENAT
KENAT
meridian5850
  • Locked
  • Question Question
Defining tangency with GD&T?
Replies
4
Views
370
ewh
ewh
Peterup
  • Locked
  • Question Question
Fully Employing Positional Tolerancing Over Rectangular Tolerancing?..
Replies
13
Views
386
zissou
zissou
aardvarkdw
  • Locked
  • Question Question
Thru To Bore Note
2
Replies
32
Views
2K
KENAT
KENAT
templetonc
  • Locked
  • Question Question
Weld Symbol
Replies
3
Views
196
Heckler
Heckler
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top