Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drafting Standards, GD&T & Tolerance Analysis

00Viggen
  • Locked
  • Question Question
Deep drilling GD&T
Replies
9
Views
311
ringman
ringman
uGlay
  • Locked
  • Question Question
ASME - where to start?
Replies
9
Views
316
MechNorth
MechNorth
rltw
  • Locked
  • Question Question
Sheet Metal GD&T Questions
Replies
2
Views
154
aardvarkdw
aardvarkdw
Precise
  • Locked
  • Question Question
Parallelism question verification
Replies
3
Views
198
JDana
JDana
powerhound
  • Locked
  • Question Question
Flatness or Profile of a Surface?
Replies
12
Views
874
ctopher
ctopher
powerhound
  • Locked
  • Question Question
Specification of tolerances
Replies
14
Views
275
jakfishjak
jakfishjak
NoWittyHandle
  • Locked
  • Question Question
Scaling Center, Dashed, Phantom, and Hidden Lines in AutoCAD
Replies
2
Views
236
looslib
looslib
squarkman
  • Locked
  • Question Question
Positional Tolerance
Replies
7
Views
181
MechNorth
MechNorth
ringman
  • Locked
  • Question Question
Tan Plane
Replies
13
Views
471
aardvarkdw
aardvarkdw
Sirius2
  • Locked
  • Question Question
Are there any Toolmakers in here? Advice Required....
Replies
14
Views
530
thundair
thundair
EnglishMuffin
  • Locked
  • Question Question
Positional Tolerance and Datum Precedence
2
Replies
38
Views
2K
ringman
ringman
tank627
  • Locked
  • Question Question
radius reversal
Replies
8
Views
464
ctopher
ctopher
snowman64
  • Locked
  • Question Question
ordinate dimensioning
Replies
14
Views
1K
drawoh
drawoh
jszymkowski
  • Locked
  • Question Question
Bidirectional tol. vs 2 single segment feature control frames
Replies
3
Views
316
MechNorth
MechNorth
jszymkowski
  • Locked
  • Question Question
Referencing a Datum feature of size multiple times
Replies
14
Views
846
KENAT
KENAT
lokho
  • Locked
  • Question Question
basic dimension versus tolerance dimension
2
Replies
23
Views
834
MechNorth
MechNorth
Seco1
  • Locked
  • Question Question
Positional Tolerance
2
Replies
27
Views
998
ewh
ewh
caseynick
  • Locked
  • Question Question
clocking question
Replies
17
Views
1K
ewh
ewh
Barce
  • Locked
  • Question Question
sheet metal GD&T starting values
Replies
3
Views
111
Barce
Barce
MechTech2000
  • Locked
  • Question Question
GD&T machined octagon centered on shaft
2
Replies
36
Views
968
kbro151
kbro151
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top