Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drafting Standards, GD&T & Tolerance Analysis

duk748
  • Locked
  • Question Question
CALLOUTS FOR SECTIONS OVER Z-Z
Replies
17
Views
315
ctopher
ctopher
kmansoor
  • Locked
  • Question Question
NUMBER OF POINTS REQUIRED FOR CMM MEASUREMENT
Replies
2
Views
601
KENAT
KENAT
steveedmonds
  • Locked
  • Question Question
Controlling finish on drawings.
Replies
5
Views
458
ctopher
ctopher
weisusu
  • Locked
  • Question Question
Process Capability Calculation
Replies
9
Views
565
PaulJackson
PaulJackson
evolDiesel
  • Locked
  • Question Question
Title Block Tollerance Vs. Notes
Replies
12
Views
756
ctopher
ctopher
michal77
  • Locked
  • Question Question
Dims from 3D vs ISO 2768
Replies
4
Views
334
michal77
michal77
benensky
  • Locked
  • Question Question
basic dimensioning of holes, c'bores & c'sinks per ISO standard
Replies
7
Views
947
KENAT
KENAT
ajn22anellie
  • Locked
  • Question Question
All Around Weld Symbol
Replies
8
Views
652
CheckerRon
CheckerRon
Kinsrow
  • Locked
  • Question Question
controlling bow of part in one direction
Replies
18
Views
829
drstrole
drstrole
Troy442
  • Locked
  • Question Question
Position-fixed or float with thread cutting screws?
Replies
5
Views
162
btrueblood
btrueblood
TJK1
  • Locked
  • Question Question
Datum dimensioning
Replies
17
Views
554
PaulJackson
PaulJackson
MachineShopGuy
  • Locked
  • Question Question
Reporting Profile on Inspection Report
Replies
10
Views
860
KENAT
KENAT
MechNorth
  • Locked
  • Question Question
Full or Partial GD&T
Replies
19
Views
1K
MechNorth
MechNorth
rvenzon
  • Locked
  • Question Question
Unknown Symbol...
2
Replies
21
Views
798
powerhound
powerhound
Tobin1
  • Locked
  • Question Question
Limit Tolerance Text Placement
Replies
3
Views
200
Tobin1
Tobin1
LONDONDERRY
  • Locked
  • Question Question
Recommend a GD&T
2
Replies
27
Views
534
MechNorth
MechNorth
dmech
  • Locked
  • Question Question
ASME Y14.41-2003 & Adobe PDF....
2
Replies
33
Views
867
fcsuper
fcsuper
fogleghorn
  • Locked
  • Question Question
Who Creates Assembly Drawings?
2
Replies
20
Views
626
KENAT
KENAT
SeasonLee
  • Locked
  • Question Question
The meaning of FRTZF without datum reference
2
Replies
30
Views
955
MechNorth
MechNorth
Gthomas191
  • Locked
  • Question Question
Counterbore Standard
Replies
7
Views
105
dgowans
dgowans
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top