Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drafting Standards, GD&T & Tolerance Analysis

KENAT
  • Locked
  • Question Question
Thread Depth Specifying - Sanity Check Requested
2 3
Replies
42
Views
2K
KENAT
KENAT
handleman
  • Locked
  • Question Question
"In line" tolerance?
2
Replies
22
Views
705
axym
axym
weisusu
  • Locked
  • Question Question
Datum Definition and Datum Usage
Replies
16
Views
569
ewh
ewh
DennisP
  • Locked
  • Question Question
Perpendicularity callout
Replies
5
Views
137
DennisP
DennisP
jaimeshawn
  • Locked
  • Question Question
Anyone ever see a double positive tolerance?
2
Replies
35
Views
2K
KENAT
KENAT
weisusu
  • Locked
  • Question Question
Primary Secondary and Tertiary Datum Planes
Replies
10
Views
228
btrueblood
btrueblood
JAS1994
  • Locked
  • Question Question
Min. Full Thread
Replies
13
Views
3K
KENAT
KENAT
PROEGUY
  • Locked
  • Question Question
help w/ level III drawings
Replies
9
Views
242
Tunalover
Tunalover
italzo
  • Locked
  • Question Question
Backflow Pressure
Replies
2
Views
73
italzo
italzo
rmaki
  • Locked
  • Question Question
Holes Normal to Contour.
Replies
6
Views
322
KENAT
KENAT
Jeeper373
  • Locked
  • Question Question
Part List and Obsolete versus Deleted
Replies
3
Views
166
KENAT
KENAT
LayneC
  • Locked
  • Question Question
block tolerances applied to comercial hardware
Replies
7
Views
144
fcsuper
fcsuper
irfan08
  • Locked
  • Question Question
Using spreadsheet for Tolerance Stackup
Replies
15
Views
1K
irfan08
irfan08
CoryPad
  • Locked
  • Question Question
Spot face specifications
Replies
3
Views
350
ctopher
ctopher
weisusu
  • Locked
  • Question Question
Basic Dimension & Surface Profile
Replies
1
Views
111
KENAT
KENAT
DIMGUY
  • Locked
  • Question Question
Urgently needed - AMGD&T True Type Font
Replies
2
Views
92
KENAT
KENAT
lsmaclea
  • Locked
  • Question Question
Circularity of a medium quality extrusion
Replies
13
Views
151
dingy2
dingy2
joedvo
  • Locked
  • Question Question
Question about pipe component drawing tolerances
Replies
4
Views
240
ctopher
ctopher
kaptn35
  • Locked
  • Question Question
outside surface breaks
Replies
5
Views
181
ewh
ewh
Luke76
  • Locked
  • Question Question
Datum Planes
Replies
10
Views
247
dingy2
dingy2
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top