Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drafting Standards, GD&T & Tolerance Analysis

michal77
  • Locked
  • Question Question
Position tolerance of the opening which is in distance from the datums
2
Replies
25
Views
741
michal77
michal77
mecassembly
  • Locked
  • Question Question
Tolerance Analysis software
Replies
1
Views
97
looslib
looslib
corvettee
  • Locked
  • Question Question
ANSI Y14.5-1994 interpretation
Replies
5
Views
740
ctopher
ctopher
ringman
  • Locked
  • Question Question
Decimal Dimensioning/Fractional Equivalents
Replies
14
Views
656
KENAT
KENAT
dgowans
  • Locked
  • Question Question
GD&T suggestions needed
Replies
5
Views
180
dgowans
dgowans
boottmills
  • Locked
  • Question Question
Engineering Change Orders
Replies
6
Views
691
KENAT
KENAT
evolDiesel
  • Locked
  • Question Question
Drawing Philosophies (help!)
2
Replies
25
Views
647
dgallup
dgallup
KENAT
  • Locked
  • Question Question
Confusing/Odd looking datums
2 3
Replies
51
Views
950
kanga147
kanga147
gmurr
  • Locked
  • Question Question
Dimensioning Repetitive Patterns (opinions?)
Replies
12
Views
286
MintJulep
M
bnmorgan
  • Locked
  • Question Question
Print check history management
2
Replies
21
Views
501
ctopher
ctopher
GTFiji
  • Locked
  • Question Question
Diameter Callout
Replies
11
Views
1K
GTFiji
GTFiji
ringman
  • Locked
  • Question Question
Decimal places required for angles
Replies
7
Views
809
KENAT
KENAT
tost
  • Locked
  • Question Question
Parallelism GD & T and angle connection
Replies
17
Views
491
drawoh
drawoh
CheckerRon
  • Locked
  • Question Question
Can Profile -Of -A-Surface have MMC on it's Datum?
Replies
13
Views
922
axym
axym
PRuggiero
  • Locked
  • Question Question
14.5m-1982 vs 14.m-1994
2
Replies
26
Views
2K
KENAT
KENAT
ringman
  • Locked
  • Question Question
Repeating Datum Feature Identifiers
Replies
7
Views
549
ewh
ewh
gmurr
  • Locked
  • Question Question
Dimensioning repeated hole patterns
Replies
8
Views
899
ewh
ewh
SeanDotson
  • Locked
  • Question Question
Sig Figs and Tolerance
Replies
10
Views
811
fcsuper
fcsuper
ringman
  • Locked
  • Question Question
Is Use of a Center plane for Tertiary Datum Legit?
2
Replies
30
Views
745
MechNorth
MechNorth
brakemeister
  • Locked
  • Question Question
General Drawing Tolerances
Replies
16
Views
315
MechNorth
MechNorth
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top