Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drafting Standards, GD&T & Tolerance Analysis

Doogan
  • Locked
  • Question Question
Title Block Tolerances
Replies
9
Views
1K
Doogan
Doogan
tost
  • Locked
  • Question Question
Basic dimension without position tolerance
Replies
17
Views
552
drawoh
drawoh
kmansoor
  • Locked
  • Question Question
runout relative to same feature's axis
Replies
9
Views
560
tost
tost
obie18
  • Locked
  • Question Question
hole patterns as datums
Replies
16
Views
954
CheckerRon
CheckerRon
ringman
  • Locked
  • Question Question
Decimal Places required with Basic Angles
Replies
9
Views
529
drawoh
drawoh
gjacc
  • Locked
  • Question Question
Multiple Assembly Parts List, MIL-STD-100 then and now
Replies
6
Views
410
gjacc
gjacc
tnboy82
  • Locked
  • Question Question
Drawing Markup Per ASTM Y14
Replies
11
Views
1K
fcsuper
fcsuper
cwdaniel
  • Locked
  • Question Question
How many angles are in a circular pattern?
4 5 6
Replies
108
Views
3K
btrueblood
btrueblood
Newty
  • Locked
  • Question Question
GD&T Datum Selection
Replies
7
Views
104
Newty
Newty
M
  • Locked
  • Question Question
More about bolt circles
Replies
5
Views
1K
btrueblood
btrueblood
ringman
  • Locked
  • Question Question
Repeated Basic dimensions
2
Replies
37
Views
2K
drawoh
drawoh
Dave K
  • Locked
  • Question Question
"TRUE LENGTH" call out
Replies
6
Views
273
Dave K
Dave K
weavedreamer
  • Locked
  • Question Question
Are Parting Lines Included, or Excluded.
Replies
9
Views
402
btrueblood
btrueblood
Slyzzzrd
  • Locked
  • Question Question
Quantities on Item Call-outs
Replies
4
Views
263
KENAT
KENAT
cmm
  • Locked
  • Question Question
plating thickness callout?
Replies
6
Views
317
ctopher
ctopher
EngJW
  • Locked
  • Question Question
Straight pipe thread
Replies
5
Views
285
EngJW
EngJW
aardvarkdw
  • Locked
  • Question Question
How to locate a part relative to the "center" of another part
2
Replies
21
Views
417
KimBellingrath
KimBellingrath
cwdaniel
  • Locked
  • Question Question
Controlling coaxial features
Replies
10
Views
495
KENAT
KENAT
rmetzger
  • Locked
  • Question Question
written standard for bill of material structuring - best resource?
Replies
5
Views
180
KENAT
KENAT
ringman
  • Locked
  • Question Question
Hole locations for holes to be match drilled later.
Replies
9
Views
758
KENAT
KENAT
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top