Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

What is the best way to dimension the depth of a cutout or slot?

Status
Not open for further replies.
kcantlon

kcantlon

Mechanical
Joined
Feb 4, 2014
Messages
3
Location
US
I need to know the best way to dimension the depth of a cutout or slot. I have square tubing with a slot cut thru all and I am not sure where the best place to add the depth.
 
Sort by date Sort by votes
If it's "thru" or "thru all", a note should suffice.

For blind slots I prefer a partial section view.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

C
  • Question Question
Symmetric to Centerline note is given to below drawing attached, need to understand how manufacturer will punch the holes at what tolerance.
Replies
16
Views
26K
Burunduk
Burunduk
MattEdwards
  • Locked
  • Question Question
Specifying the orientation of a dimension
Replies
19
Views
982
3DDave
3DDave
rollingcloud
  • Locked
  • Question Question
Is my understand of the FRTZF correct?
Replies
7
Views
5K
rollingcloud
rollingcloud
F
  • Question Question
Use the Drawing title block linear tolerance to control a Diametrical callout size - is it correct?
Replies
3
Views
2K
Burunduk
Burunduk
SeasonLee
  • Locked
  • Question Question
Is this the right way to measure the profile ?
Replies
15
Views
802
SeasonLee
SeasonLee

Part and Inventory Search

Sponsor

Back
Top