Eng-Tips is the largest forum for Engineering Professionals on the Internet.

Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!

  • Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Use the Drawing title block linear tolerance to control a Diametrical callout size - is it correct? 1

Frokilin

Mechanical
Joined
Feb 6, 2025
Messages
20
Would that diametral 67.5 size tolerance be covered with that linear tolerance note on the drawing notes?


1743733131746.png1743733195118.png
 
Yes.
But those seem to be millimeters,
And therefore that method of assigning a tolerance depending on the number of decimals, is not suitable, because you are not allowed trailing zeros for millimetric dimensions.
 
Thanks Burunduk. That is because of para. 4.3.1 (b), right?
 

Part and Inventory Search

Sponsor

Back
Top