Weldment Features in Feature Manager Tree

[MimiN63]

Hi, I'm working with weldments alot lately and must use many seperate members to create my model. Whether I only have a few of them or many more, I find it a waste of time to keep editing the feature or checking back to my hard-copy references to remember what kinds of members i used and where. Is there another way to have the name of the members show up in the FMT (like Hole Wizard does) without having to check the "Name Feature on Creation" setting under options or manually naming them? Even then, you'd have to go change the names if you were to change member type &/or size. Any suggestions?

 

[SBaugh]

You will have to rename the feature in the FM tree manually or add a Comment. Adding a comment will show up when you hover over the feature.

Regards,

Scott Baugh, CSWP
3DVision Technologies

http://www.3dvisiontech.com

http://www.scottjbaugh.com

faq731-376
faq559-716 - SW Fora Users

 

[CorBlimeyLimey]

Would be good for an Enhancement Rquest!

& all the best.