Eng-Tips is the largest forum for Engineering Professionals on the Internet.

Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!

  • Congratulations dmapguru on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Weldment Features in Feature Manager Tree

Status
Not open for further replies.

MimiN63

Mechanical
Joined
Oct 31, 2003
Messages
45
Location
US
Hi, I'm working with weldments alot lately and must use many seperate members to create my model. Whether I only have a few of them or many more, I find it a waste of time to keep editing the feature or checking back to my hard-copy references to remember what kinds of members i used and where. Is there another way to have the name of the members show up in the FMT (like Hole Wizard does) without having to check the "Name Feature on Creation" setting under options or manually naming them? Even then, you'd have to go change the names if you were to change member type &/or size. Any suggestions?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top