eltriplehp
Automotive
Welding module for NX6, simply can't do the job when the intersection has one curve surface, i use fillet , groove, but no way... it's necessary to create an "artificial" edge?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
WELDING ON NX6 NOT WORKING BTW CILINDERS AND FLAT SURFACES 1
- Thread starter eltriplehp
- Start date
- Status
-
1
- Thread starter
- #3
eltriplehp
Automotive
is not that, i explain better the problem:
with welding assistant, in modeling, If the fit is not a perfect cilinder in a perfect hole (that works) simply impossible to make weld, give messages about topology and/or initial and final points.Some times in preview i reach to see the profile but at the end fails.
thx for the help
with welding assistant, in modeling, If the fit is not a perfect cilinder in a perfect hole (that works) simply impossible to make weld, give messages about topology and/or initial and final points.Some times in preview i reach to see the profile but at the end fails.
thx for the help
- Status
Similar threads
