Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Walls Buckling in ETABS
- Thread starter melsawaf
- Start date
no it doesnt. etabs considers the wall as a stiff member and he wont do any buckling check while designing the wall.
pay attention if u are using pier definition to draw a single wall (not braced in the prependicular direction), then buckling should be checked manually or loads exported to another software where buckling is considered
pay attention if u are using pier definition to draw a single wall (not braced in the prependicular direction), then buckling should be checked manually or loads exported to another software where buckling is considered
- Status
Similar threads
- Question