When using the auto wind load feature in ETABS, is there a way to check the area being used to compute the wind forces and other parameters? I couldn’t find the areas in the generated report. Is there any way to export or verify this information directly within the software?"
Eng-Tips is the largest forum for Engineering Professionals on the Internet.
Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!
-
Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Auto Wind - ETABS
- Thread starter Johnamaro
- Start date
Similar threads
- Question