yoyoeleven19
Civil/Environmental
- Jul 28, 2025
- 1
Hi I'm new to etabs
I want to draw a shell and for that I need the intersection of two beams, and the intersection that the program itself detects is not really an intersection.
P.S I enabled intersection snap and draw a joint for this but when zoom in , it's not correct
I use etabs 2019
I want to draw a shell and for that I need the intersection of two beams, and the intersection that the program itself detects is not really an intersection.
P.S I enabled intersection snap and draw a joint for this but when zoom in , it's not correct
I use etabs 2019