Eng-Tips is the largest forum for Engineering Professionals on the Internet.
Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!
-
Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
UTS and Allowable shear stress values for Carbon Steel ASTM A350 LF2 3
- Thread starter VBH
- Start date
-
2
- #2
How about this approach, the allowable stress for ASME SA 350 LF2 at 750 deg F is 14.8 Ksi (per ASME B&PV Code, Section II, Part D). At 750 deg F, the allowable stress above is controlled by time dependent effects - like creep deformation. If your calculated stresses are at or below this value, you should be fine with plenty of design margin.
-
1
- #3
DiegoMartinez
Petroleum
A350 Gr Lf2 is the fitting material for "LOW" temp. service. Where are you using this with such a high temp?
- Status
Similar threads
- Question
- Locked
- Question
- Locked