Hi! I'm working on a problem where wind hits a wall like panel and it gets displaced. I'm solving this problem and afterwards I need to work on the new displaced geometry. Is there any way to write the displaced panel geometry on a file and then just import it in ANSYS in order to work on the new displaced geometry?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
use new displaced geometry
- Thread starter sosat1012
- Start date
- Status
Similar threads
- Question
- Locked
- Question
- Locked
- Question
- Locked
- Question