Eng-Tips is the largest forum for Engineering Professionals on the Internet.

Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!

Register Log in
  • Congratulations dmapguru on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

How to validate results from a topology-optimized geometry in ANSYS Workbench 2021 R2

Status
Not open for further replies.
andradesilva

andradesilva

Materials
Joined
Jun 20, 2017
Messages
125
Location
PT
Hi,

I have an .STL file, which I exported after a Topology Optimization routine, based on Structural static analysis, in ANSYS Workbench 2021 R2. However, I can't link directly my Topology Optimization analysis to another static analysis for design validation. It gives my error and I think it's because of the .stl file not being compatible with Design modeler. Any ideas on how to validate topology-optimized geometries in ANSYS Workbench?

I thank you in advance,
Best regards,
 
Status
Not open for further replies.

Similar threads

struclearner
  • Question Question
Modelling Tapped Bolted Joint by Line Body in ANSYS Workbench
Replies
0
Views
4K
struclearner
struclearner
H
  • Locked
  • Question Question
how to apply triangular load on an area, in ANSYS Workbench static module
Replies
1
Views
3K
karachun
karachun
H
  • Locked
  • Question Question
Plasticity behaviour is not being computed in a non-linear analysis in ANSYS Mechanical APDL 2024 r2
Replies
0
Views
2K
hmsilva
H
shiraz883
  • Locked
  • Question Question
Different results in ANSYS 2021 vs ANSYS 2022
Replies
0
Views
520
shiraz883
shiraz883
X
  • Locked
  • Question Question
ANSYS mechanical : How to read the dimensions which are defined as function of other dimensions in UGNX as parameters in ANSYS?
Replies
0
Views
1K
xinyu3liu
X

Part and Inventory Search

Sponsor

Back
Top