Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Unit Conversion
- Thread starter dhank
- Start date
There used to be a DOS program included with UG that would change the units & scale the part during the conversion. You just have to run it from a DOS prompt or terminal window (UNIX). I think the name of the program is ug_convert_part.exe & is found in the UGII directory. If you have the documentation installed (you should if you don't), do a search for the program name & that should give you all the info you need. If not, you can call GTAC & have them walk you through how to do it.
Tim Flater
Senior Designer
Enkei America, Inc.
Tim Flater
Senior Designer
Enkei America, Inc.
Please go thru these threads:
Hope this helps.
Hope this helps.
- Status