Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Unable to open geometry model database.

  • Thread starter Thread starter YouLiang
  • Start date Start date
Status
Not open for further replies.
Y

YouLiang

Guest
Hi all, this one really got me....



In pro-motion, whenever a contact region is defined, the motion analysis run failed and the message given is, Pro/Mechanica cannot proceed with the analysis because it could not open the geometry model database needed for contact regions or measures.



Thanks for any help given!
 
Status
Not open for further replies.

Similar threads

BryanAyers
  • Locked
  • Question Question
Creo 9 drawing's tables, "part perimeter", how to setup?
Replies
0
Views
847
BryanAyers
BryanAyers
jasongBSME
  • Locked
  • Question Question
Converting from Pro/Mechanica to Creo Simulate
Replies
0
Views
800
jasongBSME
jasongBSME
DKrol
  • Locked
  • Question Question
Export STEP file from Creo to Solidworks
Replies
1
Views
810
goeasyon
goeasyon
Bobfromoh
  • Locked
  • Question Question
Model not tied down
Replies
0
Views
688
Bobfromoh
Bobfromoh
Bobfromoh
  • Locked
  • Question Question
Bolting in Axisymmetric model
Replies
0
Views
728
Bobfromoh
Bobfromoh

Part and Inventory Search

Sponsor

Back
Top