jasongBSME
Mechanical
thread828-355322
I am skeptical this thread will gain any traction, but is anyone familiar with the conversion process to go from a model created in Pro/Mechanica to Creo Simulate? From my limited exposure to either Creo Simulate or Pro/Mechanica, it seems the most viable avenue would be converting the Mechancia Neutral File, .MNF, into the FEM Neutral File, .FNF, for Creo. While the files are in ASCII format, this seems likely to be quite the undertaking.
I would appreciate any suggestions/tips.
Best,
J.
I am skeptical this thread will gain any traction, but is anyone familiar with the conversion process to go from a model created in Pro/Mechanica to Creo Simulate? From my limited exposure to either Creo Simulate or Pro/Mechanica, it seems the most viable avenue would be converting the Mechancia Neutral File, .MNF, into the FEM Neutral File, .FNF, for Creo. While the files are in ASCII format, this seems likely to be quite the undertaking.
I would appreciate any suggestions/tips.
Best,
J.