Turning prospective view off?

[UMDpru]

Anyone know how to permanently turn perspective view off as a default? It is on right now everytime i open a document in SW06 and I would like it to be turned off by defualt.

Thanks,

Adam

 

[CorBlimeyLimey]

The view seen when a doc' is opened should be the one that was last saved. Is this not what is happening?

No, you cannot turn the perspective view off.

 

[UMDpru]

the perspective view turns on by default irrespective of the state the model view was in when saved.

im pretty sure my copy at home doesnt do this...

thats why i was asking.

 

[CorBlimeyLimey]

Can you copy your settings from home?

If not try faq559-507

 

[UMDpru]

Thanks for the advice. Ill try and see if i can find any different settings on my home machine.

 

[rockguy]

Maybe you saved this setting in your model file template?

Rob Rodriguez CSWP

http://www.axiscadsolutions.com

http://www.robrodriguez.com

http://designsmarter.typepad.com/rob_rodriguez/

Eastern Region SWUGN Representative

http://www.swugn.org

http://www.nvtswug.com

SW 2007 SP 2.0

 

[CorBlimeyLimey]

Rob ... I don't know of a setting which affects how a doc' is opened. Do you? I thought it was just the last saved view.

 

[rockguy]

I haven't tested it to see but if you can set perspective as "on" in your model template then it will be "on" when you open that file until it's turned off I believe.

I may be confused...are we talking about VIEW/DISPLAY/PERSPECTIVE or an iso view?

Rob Rodriguez CSWP

http://www.axiscadsolutions.com

http://www.robrodriguez.com

http://designsmarter.typepad.com/rob_rodriguez/

Eastern Region SWUGN Representative

http://www.swugn.org

http://www.nvtswug.com

SW 2007 SP 2.0

 

[UMDpru]

view>display>perspective

thanks for the tips