Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

The ratio of deformation speed to wave speed exceeds 1.0000 in at least one element.

Status
Not open for further replies.
S Balakumaran

S Balakumaran

Civil/Environmental
Joined
Apr 4, 2022
Messages
4
Location
IN
Hello friends! I am simulating an impact analysis. During analysis, I encounter the following error.

The ratio of deformation speed to wave speed exceeds 1.0000 in at least one element. This usually indicates an error with the model definition. Additional diagnostic information may be found in the message file.

What should I do to resolve this error? Please help me. Thanks in advance!!
 
Sort by date Sort by votes
Status
Not open for further replies.

Similar threads

X4vier
  • Question Question
Correct design and detailing of X bracing in the middle Brace-to-Brace connection? (one story, so not beam there)
Replies
7
Views
11K
Deker
Deker
engjg
  • Locked
  • Question Question
Dynamic Load Allowance (IM) | AASHTO | Minimum Vehicle Design Speed
Replies
1
Views
1K
BridgeSmith
BridgeSmith
kevin555582
  • Question Question
Concrete Anchor Design in Top of Wall at Corner
Replies
1
Views
3K
Rsd789
Rsd789
ARPASEVAN
  • Question Question
Pin connection at the edge of a concrete deck - CSI SAFE
Replies
0
Views
3K
ARPASEVAN
ARPASEVAN
KootK
  • Locked
  • Question Question
Guide to the Design of Common Irregularities in Buildings
Replies
5
Views
5K
KootK
KootK

Part and Inventory Search

Sponsor

Back
Top