CADFlyer
Automotive
- May 3, 2007
- 96
Are there keboard shortcuts available for Solidworks for symbols such as centerline, +/-, degree, etc?
i have found a few ALT codes that will work, but i was hoping for something similar to AutoCAD's %%p & %%c.
i know they are out there, at least some, because i have stumbled upon <T#-1> for the number 1 (or any other number) inside a Triangle, also C for Circle & S for Square <S#-5>
thanks in advance!
Mark
i have found a few ALT codes that will work, but i was hoping for something similar to AutoCAD's %%p & %%c.
i know they are out there, at least some, because i have stumbled upon <T#-1> for the number 1 (or any other number) inside a Triangle, also C for Circle & S for Square <S#-5>
thanks in advance!
Mark