Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

SW opening file error

Status
Not open for further replies.

documenteria

Mechanical
Joined
May 18, 2010
Messages
2
Location
SE
When I try to open a part or assembly file I get this message: "An error has occurred and SolidWorks need to re-start"
If I try to open a drawing file it start OK, with that .SLDDRW open I can open or create any part or assembly file.
I have un-installed and re-installed SW, still the same.
SW 2010 have been used on same PC for months with no problem.
I am using Vista Business, memory 2048MB. Graphics: 256nVIDA Quatro FX570.
Any idea?
So fare I will start work by first opening a drawing.

/Bjorn
 
documenteria,

Are all your assemblies failing, or just one?

Critter.gif
JHG
 
If you have a x32 system, try setting the /3GB switch.
thread559-155411

If that improves the situation, add more RAM.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top