Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Suitable Units Thermo-Mech Analysis

Status
Not open for further replies.
Eser

Eser

Mechanical
Joined
Jan 27, 2005
Messages
18
Location
DE

Hi all!

I have a question regarding the selection of suitable units for the calculation of a thermal-mechanical analysis. Inorder to have the stress in Mpa what should be the unit of:

-Specific Heat
-Conductivity
-Mass Density

If the units of force is N and the distances are in mm.

Thanks in advance,

Eser
 
Status
Not open for further replies.

Similar threads

Anurag K
  • Question Question
Hydrostatic bearing CFD analysis
Replies
1
Views
371
karachun
karachun
H
  • Locked
  • Question Question
Plasticity behaviour is not being computed in a non-linear analysis in ANSYS Mechanical APDL 2024 r2
Replies
0
Views
2K
hmsilva
H
Anatoly_k
  • Locked
  • Question Question
Pipe Burst Pressure - elastic-plastic analysis strange asymmetry
Replies
0
Views
914
Anatoly_k
Anatoly_k
R
  • Locked
Guidance on Settlement Analysis of Steam Generator in Oil Plant Using ANSYS
Replies
0
Views
798
Rabea-19
R
andradesilva
  • Locked
  • Question Question
modal analysis in ANSYS Mechanical APDL 2020 R2: How to see graphical results without mesh/elements
Replies
1
Views
916
NRP99
NRP99

Part and Inventory Search

Sponsor

Back
Top