Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Step and Touch Voltage measurement procedure?

Status
Not open for further replies.
Paykon

Paykon

Electrical
Joined
May 8, 2009
Messages
11
Could anybody explain to me where I can find procedure for measuring step and touch potential?

Regards


Peter
 
Sort by date Sort by votes
And Std 81-1983, IEEE Guide for Measuring Earth Resistivity, Ground Impedance, and Earth Surface Potentials of a Ground System Part 1: Normal Measurements
 
Upvote 0 Downvote
Depends on which part of the world you are.
For example, in Australia the AS/NZS 3835/2006 covers this issue.

Regards,
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

NickParker
  • Question Question
Harmonic Voltage factor and THD
Replies
0
Views
584
NickParker
NickParker
NickParker
  • Locked
  • Question Question
Plant Grounding - Step and Touch Voltage
Replies
5
Views
616
cuky2000
cuky2000
jmelo28
  • Locked
  • Question Question
EN 50522 Calculation of Permissible Touch Voltage
Replies
1
Views
549
jmelo28
jmelo28
R
  • Question Question
FAT : zero sequence impedance measurement test
Replies
2
Views
4K
Kiribanda
Kiribanda
J
  • Question Question
Directly from 30 kV to 0.4 kV? Or step down the voltage in stages, typically from 30 kV to 6 kV, then from 6 kV to 0.4 kV.
Replies
12
Views
18K
electricuwe
electricuwe

Part and Inventory Search

Sponsor

Back
Top