Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Stents Analysis

Status
Not open for further replies.
yomi213

yomi213

Industrial
Joined
Oct 20, 2010
Messages
15
How to analyse stent crimping, bending, expansion in Ansys Workbench?
What diameters are used in designing, crimping and expanding the stents?(If the stent nominal diameter is 3 mm)
The stents are designed in Solidworks.
How to apply Loads (pressure/ force),fixtures etc?
Can you please help me explaining in detail?


Thanks in advance
 
Status
Not open for further replies.

Similar threads

Anurag K
  • Question Question
Hydrostatic bearing CFD analysis
Replies
1
Views
359
karachun
karachun
Anatoly_k
  • Locked
  • Question Question
Pipe Burst Pressure - elastic-plastic analysis strange asymmetry
Replies
0
Views
911
Anatoly_k
Anatoly_k
R
  • Locked
Guidance on Settlement Analysis of Steam Generator in Oil Plant Using ANSYS
Replies
0
Views
787
Rabea-19
R
H
  • Locked
  • Question Question
Plasticity behaviour is not being computed in a non-linear analysis in ANSYS Mechanical APDL 2024 r2
Replies
0
Views
2K
hmsilva
H
LIAM_7
  • Locked
  • Question Question
ANSYS and fatigue analysis
Replies
0
Views
437
LIAM_7
LIAM_7

Part and Inventory Search

Sponsor

Back
Top