Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Steel bracing in sap

Status
Not open for further replies.
hamedthelord

hamedthelord

Structural
Joined
Mar 3, 2012
Messages
6
Location
SA
is there any way to prevent area from transferring load to roof bracing instead of moving bracing and making joint constrains?
 
Sort by date Sort by votes
Select the frames and then "Assign -> Frames -> Load Transfer Options...".
Untick the check box and the selected frames shall not be loaded from the areas.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

N
  • Question Question
SAP 2000 - Center of Mass and Center of Rigidity
Replies
0
Views
6K
Neeka
N
a_urbs
  • Locked
  • Question Question
Using Section Cuts in SAP for Storey Weight
Replies
0
Views
1K
a_urbs
a_urbs
giofed
  • Locked
  • Question Question
SAP 2000 Shell twisting moment
Replies
1
Views
1K
JoshPlumSE
JoshPlumSE
juandavidguzman
  • Locked
  • Question Question
SAP2000 Nonlinear Analysis Setup for Steel Design: Notial loads
Replies
2
Views
2K
STpipe
STpipe
K
  • Question Question
C# SAP2000 API v26.2.0 - Load Patterns Not Appearing in "Load Pattern Definitions" Table Despite Being Created
Replies
0
Views
6K
keremsari
K

Part and Inventory Search

Sponsor

Back
Top