Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

standards for "crush washer" seals and sources for AN info

Status
Not open for further replies.

Andy330hp

Mechanical
Joined
Feb 27, 2003
Messages
124
Location
US
Does anybody know of a documented standard, SAE or otherwise, for proper crush washer seals. Information I'm interested in is the dimensions and surface finish requirements for the ports and fittings, as well as standard sizes for the crush washers.

The only mention I've found of ANY standard is an old army-navy (AN) standard, AN900 and AN901. However, I have not been able to find the actual standard. Does anybody know where this information is available?
 
Andy330hp,

Have you checked the FAQ Where can I get SAE standards from? (faq14-803) yet?


Best regards,

Matthew Ian Loew
"Luck is the residue of design."
Branch Rickey


Please see FAQ731-376 for tips on how to make the best use of Eng-Tips Fora.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top