Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Sharpen display setting 5 as defualt? ST2
- Thread starter workinu30
- Start date
Unless you're only dealing with small simple models you probably don't want to do that, it makes a massive hit on performance.
If you just want to get rid of the 'polygons' then '3' is adequate most of the time.
I'm afraid I'm not sure how to change the default.
If you just want to get rid of the 'polygons' then '3' is adequate most of the time.
I'm afraid I'm not sure how to change the default.
Posting guidelines faq731-376 (probably not aimed specifically at you)
What is Engineering anyway: faq1088-1484
What is Engineering anyway: faq1088-1484
- Status
Similar threads
- Locked
- Question
