I've seen this issue forever in SE ST9 and never been able to figure out why it happens.
I'll have an assembly, and seemingly out of nowhere a part will 'jump' across the screen and be constrained in some really strange place or orientation, and it'll show some blown up constraints. If I click on the constraint with the error, it'll highlight a surface, hole, etc. that it's constrained to and it'll be out in space, not at all where the ACTUAL surface/hole/etc is.
If I close edge and open it back up it fixes it, but I've noticed with certain assemblies it just happens over and over and it's really frustration. Any idea why this is happening?
I'll have an assembly, and seemingly out of nowhere a part will 'jump' across the screen and be constrained in some really strange place or orientation, and it'll show some blown up constraints. If I click on the constraint with the error, it'll highlight a surface, hole, etc. that it's constrained to and it'll be out in space, not at all where the ACTUAL surface/hole/etc is.
If I close edge and open it back up it fixes it, but I've noticed with certain assemblies it just happens over and over and it's really frustration. Any idea why this is happening?