Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

S-Function in xPc-Target don't work

Thread starter gonse
Start date Oct 15, 2003

Status: Not open for further replies.

Oct 15, 2003

gonse

Electrical

I made a Simulink model, where i'm using an s-function within.
Under Simulink everything is alright and the function (c++) multiply the both input datas, but after uploading on the
target PC and starting the model there the result is zero.

I'm using the MSVC-Compiler.
Do I have to include the c-file in a special way to the model?

Thanks a lot,
Stefan