Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Running ETFE in a hot runner mold.

Status
Not open for further replies.
jerzy

jerzy

Mechanical
Aug 26, 2001
68
I'm considering an application which might require sequential gating (using valved hot runner gates) using the fluoropolymer ETFE. Has anyone used hot runners with this resin?

Thanks

Jerzy
 
Status
Not open for further replies.

Similar threads

Buckshott00
  • Locked
  • Question
Process Setting for Improved Over-molding to prevent delamination In Molded Hytrel
Replies
0
Views
862
Buckshott00
Buckshott00
clyde Verse
  • Locked
  • Question
Any way to produce a 100% same plastic lampshell without injection mold?
Replies
5
Views
1K
Pud
Pud
cityjack
  • Locked
  • Question
Mold program to 3D model. How?
Replies
0
Views
182
cityjack
cityjack
Splint
  • Locked
  • Question
Rotomolding materials suppliers in Australia - small quantities
Replies
0
Views
714
Splint
Splint
Trevor Williams
  • Locked
  • Question
Cutting HDPE Tote Hot Wire
Replies
4
Views
520
itsmoked
itsmoked

Part and Inventory Search

Sponsor

Back
Top Bottom