Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Restart a multi-loadstep analysis

Status
Not open for further replies.

bridgehl

Civil/Environmental
Joined
Dec 23, 2006
Messages
35
Location
JP
Hi everyone,

I have a transient analysis with 2 loadsteps. Each loadstep has different loads and boundary conditions. I set the RESCONTROL for 10 points for all loadsteps.

Unfortunately, my analysis is not converged within the fist loadstep. So, if I only change the timestep and restart this calculation, do I need to re-declare the boundary conditions and loads for the the first and the second load steps?

Thank you very much.
Regards,
Bridge.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top