Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Relative Modulus in Prony Series

Status
Not open for further replies.

Zaishan

Mechanical
Joined
May 12, 2007
Messages
1
Location
CN
How does ANSYS convert the relative moduli it inputs (or stores itself after curve fitting) to the actual moduli? I can't figure out how is it possible to get the shear and bulk moduli from the input data.

Is it done through the elastic modulus that is input through the MP command, by using a relation like G=E/(2(1+pr))...?

If yes, then considering that I have only tensile relaxation curves for shear and bulk moduli, what value of E should I input?

any other suggestions?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top