Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Reg. Trademark symbol 1
- Thread starter rep001
- Start date
UG fonts are not true-type, they are special pen movement commands.
What we used to do see what characters where in the font files was to create a note with every key on the keyboard, both normal and shifted. Then highlight the note and change the font and see what appears.
"Wildfires are dangerous, hard to control, and economically catastrophic."
Ben Loosli
Sr IS Technologist
L-3 Communications
What we used to do see what characters where in the font files was to create a note with every key on the keyboard, both normal and shifted. Then highlight the note and change the font and see what appears.
"Wildfires are dangerous, hard to control, and economically catastrophic."
Ben Loosli
Sr IS Technologist
L-3 Communications
-
1
- #3
JohnRBaker
Mechanical
To find all of the 'officially' supported special symbols supported in 'BLOCKFONT', go to the user doc's and search on "blockfont" and select the first item on the list of results.
John R. Baker, P.E.
Product "Evangelist"
NX Product Line
UGS Corp
Cypress, CA
John R. Baker, P.E.
Product "Evangelist"
NX Product Line
UGS Corp
Cypress, CA
If you are using a font other than blockfont there is also a command to change the font within the same note. Use <fn><f> where 'n' is the font number you want.
So your note will look something like this: "blah blah blah <Fn>$z<F> blah blah blah"
Hopefully your text will be more interesting than mine.
So your note will look something like this: "blah blah blah <Fn>$z<F> blah blah blah"
Hopefully your text will be more interesting than mine.
- Thread starter
- #6
- Status