Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

"explicit" after using "if" on a variable

Status
Not open for further replies.
IM1990

IM1990

Structural
Joined
May 23, 2013
Messages
1
Location
PL
After using "if" to define one of the variables i tried to use “explicit,ALL” but it marks this variable as undefined. Is there a way to display all the numbers in this equation
 
Sort by date Sort by votes
Explicit is extremely limited. Read the help entry; explicit cannot always be applied to subordinate equations, particularly if the subordinate equation cannot be attached to an "explicit"

TTFN
faq731-376
7ofakss

Need help writing a question or understanding a reply? forum1529
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

yuriy_biks
  • Locked
  • Question Question
"This value must be a scalar" issue in the FOR loop Mathcad Prime 9
Replies
12
Views
2K
3DDave
3DDave
wvisgauss
  • Locked
  • Question Question
Need help completing an "If' statement
Replies
4
Views
1K
IRstuff
IRstuff
gatron2
  • Locked
  • Question Question
help with undefined variable
Replies
8
Views
2K
rmix22
rmix22
PNachtwey
  • Locked
  • Question Question
Is there an easy way to tell if a variable or function has been defined.
Replies
9
Views
2K
dik
dik
gmprox23
  • Locked
  • Question Question
Defining matrix variable to get numerical solution to the Winkler foundation differential equation
Replies
4
Views
1K
Stress_Eng
Stress_Eng

Part and Inventory Search

Sponsor

Back
Top