Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Proe Vs. Mastercam

  • Thread starter Thread starter cristelino
  • Start date Start date
Status
Not open for further replies.
tinag,


So your still using pro manufacturing. This has been the topic from all along. I do not use posts from ptc or gpost either. I have my friend at "camnet" build my posts for me. I do have some "gposts" posts but I don't use them. As long as your are only posting from pro man then I would be willing to say that you prefer pro man over mastercam and other programs like it. Big differance betweeen posting and building tool path.


smiley2.gif
 
Yes, we still use pro man to create the toolpaths, we then post using the third party software.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top