Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Creo: Reducing File Size for Mastercam

Status
Not open for further replies.

jombfish

Mechanical
Jun 30, 2022
2
Hello all.

I have made this model (image included) which is being machined onto a tray to which it can be printed on.

The problem comes from the amount of features are included on each cavity. I am trying to send the file back to the machine shop but the file is too large for the operator to load on Mastercam. The details are important for locating and printing accuracy.

Is there any advice out there on regards to saving, shrinkwrapping, or changing features, or any other advice on this?

Thanks all

fishfishfish_kwadh0.png
 
Replies continue below

Recommended for you

Send a single cavity to MasterCam and let MasterCam do the patterning.

"Wildfires are dangerous, hard to control, and economically catastrophic."

Ben Loosli
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor