Eng-Tips is the largest forum for Engineering Professionals on the Internet.

Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!

Register Log in
  • Congratulations dmapguru on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

problems in blow-moulding simulation in ANSYS Polyflow

Status
Not open for further replies.
andradesilva

andradesilva

Materials
Joined
Jun 20, 2017
Messages
125
Location
PT
Hi,

I am doing a blow-moulding simulation in ANSYS Polyflow. I am simulating the inflation of a silicone rubber, by means of air flow (pressure). Shall I use the viscoelastic model (KBK-Z, for instance) or the Newtonian model will do?

I thank you in advance,
Best regards,
 
Status
Not open for further replies.

Similar threads

struclearner
  • Question Question
Modelling Tapped Bolted Joint by Line Body in ANSYS Workbench
Replies
0
Views
4K
struclearner
struclearner
X
  • Locked
  • Question Question
ANSYS mechanical : How to read the dimensions which are defined as function of other dimensions in UGNX as parameters in ANSYS?
Replies
0
Views
1K
xinyu3liu
X
O
  • Locked
  • Question Question
ansys civata
Replies
0
Views
2K
oktaeng1
O
R
  • Locked
Guidance on Settlement Analysis of Steam Generator in Oil Plant Using ANSYS
Replies
0
Views
850
Rabea-19
R
H
  • Locked
  • Question Question
Plasticity behaviour is not being computed in a non-linear analysis in ANSYS Mechanical APDL 2024 r2
Replies
0
Views
2K
hmsilva
H

Part and Inventory Search

Sponsor

Back
Top