Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Problem with hole table

  • Thread starter Thread starter Cadmus
  • Start date Start date
C

Cadmus

Guest
After creating a base plate with a series of holes, then I patterned these holes to complete the base plate. I created my drawing using the hole table-no problems so far. I then discovered that I needed some of the holes to be blind instead of through holes - hole table updated correctly. Then I changed the holes back to through holes - table will not update, still reads these pattered holes as blind. Also the hole note still sees them as blind. Any suggestions would be really helpful.
 
I hope by performing a Tools> Rebuild All > Save within the model will update the Hole table.
 

Part and Inventory Search

Sponsor

Back
Top