Oct 12, 2004 #1 SliphouseMaster Chemical Oct 12, 2004 2 Currently our process is showing that 35% of product has a high rate of pinholes. How can we reduce this, what factors should we be looking at?
Currently our process is showing that 35% of product has a high rate of pinholes. How can we reduce this, what factors should we be looking at?
Oct 22, 2004 #2 EdStainless Materials May 20, 2004 16,283 The two things that come to mind are contamination and air. Are you sure that your de-aireation is working well? = = = = = = = = = = = = = = = = = = = = Corrosion never sleeps, but it can be managed. http://www.trenttube.com/Trent/tech_form.htm Upvote 0 Downvote
The two things that come to mind are contamination and air. Are you sure that your de-aireation is working well? = = = = = = = = = = = = = = = = = = = = Corrosion never sleeps, but it can be managed. http://www.trenttube.com/Trent/tech_form.htm
Oct 22, 2004 Thread starter #3 SliphouseMaster Chemical Oct 12, 2004 2 currently we are studying the effectiveness off our Red Jakects. As well as the ID of the spreaders used by the casters. Upvote 0 Downvote
currently we are studying the effectiveness off our Red Jakects. As well as the ID of the spreaders used by the casters.
