T
tdx99
Guest
Hi All,
I am using a pentable when printing to a pdf. Everything works fine except the width of sketched lines are not printed at the right width. They look to be the same lineweight as geometry. I have set the sketched lines to different user defined colors, but the issue still persists. If I don't use the pentable, the sketched lines show up fine, but now everything else is too thick to my liking.
Is there anyway I can print sketched lines at their set weight and still use the pentable?
I have 8 pens configured with the default colors and entity type.
Using Creo 2
Thanks.
I am using a pentable when printing to a pdf. Everything works fine except the width of sketched lines are not printed at the right width. They look to be the same lineweight as geometry. I have set the sketched lines to different user defined colors, but the issue still persists. If I don't use the pentable, the sketched lines show up fine, but now everything else is too thick to my liking.
Is there anyway I can print sketched lines at their set weight and still use the pentable?
I have 8 pens configured with the default colors and entity type.
Using Creo 2
Thanks.
Last edited:
