S
saspinall
Guest
Hello
Does anyone have any experience with Creo 6 and Teamcenter 11 working together. We use them in the company I am currently at, but the system is not well set up, so I have suggested the use of a Pro/Library system...but seeing as the Teamcenter setup uses Workspaces (its still a folder on your pc but Teamcenter calls it Workspaces. Can have several different workspaces under load point, but cant cross populate from one to another).
Populating a small library area on my C drive, and my local config pro_library_dir pointing to this works in that I can get the parts in to a new assy, but Teamcenter wont allow upload as the "library" parts are not in the currently selected Workspace.
Thanks in advance
Stu
Does anyone have any experience with Creo 6 and Teamcenter 11 working together. We use them in the company I am currently at, but the system is not well set up, so I have suggested the use of a Pro/Library system...but seeing as the Teamcenter setup uses Workspaces (its still a folder on your pc but Teamcenter calls it Workspaces. Can have several different workspaces under load point, but cant cross populate from one to another).
Populating a small library area on my C drive, and my local config pro_library_dir pointing to this works in that I can get the parts in to a new assy, but Teamcenter wont allow upload as the "library" parts are not in the currently selected Workspace.
Thanks in advance
Stu
