Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

PE film with holes 6mm

Status
Not open for further replies.

IoannisP

Mechanical
Mar 13, 2020
19
Hello everyone,

Any ideas how can I produce a PE film roll 70cm width single layer with holes without having a punching machine? To produce it while extrusion or printing or either after all these.
 
Replies continue below

Recommended for you

So you want holes without using a punch? What about a drill, or a heating element shaped appropriately?

Dan - Owner
Footwell%20Animation%20Tiny.gif
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor