Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Part Trouble

Status
Not open for further replies.

pietro25

Mechanical
May 31, 2004
1
CA
I am "new" to inventor but seem to be getting a good grasp of it. I am creating a cup like part but having trouble drawing one of the components....

The part I am drawing is VERY similar to a ladle. I got the "cup" part done but I am having trouble with the "handle". I cannot draw the handle attached to the cup. I do not know how to get the handle to go "UP on a ANGLE". If anyone can help it would be greatly appreciated.
Thank you.
 
Replies continue below

Recommended for you

Sounds like you need to sweep a section along a path. Create a sketch on the mid plane of the cup then sketch the handle path. Then place another sketch perp top this for the profile. Then sweep.

Sean Dotson, PE
Autodesk Inventor Certified Expert
Autodesk Inventor Tutorials & More
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top