Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Overhead welding

Status
Not open for further replies.
sail7seas

sail7seas

Structural
Joined
May 17, 2005
Messages
5
Location
US
I recall reading and using a fifty percent reduction in weld section properties for 'overhead welding'.
I still applicable today? If so where can I find it written? Thank you in advance.
 
Sort by date Sort by votes
Not familiar with that limitation or restriction.

Best regards - Al
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

andyecho
  • Locked
  • Question Question
UK fabricator first D1.1 welding job
Replies
0
Views
880
andyecho
andyecho
dik
  • Locked
  • Question Question
Welding Symbol
Replies
6
Views
2K
dik
dik
Karik87
  • Locked
  • Question Question
Production welding position qualified by box tube test
Replies
0
Views
965
Karik87
Karik87
FernandoL
  • Locked
  • Question Question
butt joint welding (dissimilar thicknesses) with impact requirement
Replies
0
Views
414
FernandoL
FernandoL
AAZOMPA
  • Locked
  • Question Question
TO QUALIFY A WELDING PROCEDURE (PQR
Replies
0
Views
318
AAZOMPA
AAZOMPA

Part and Inventory Search

Sponsor

Back
Top