Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

O.D. Check for Bushing

Status
Not open for further replies.
JLaGrow

JLaGrow

Mechanical
Joined
Jan 20, 2011
Messages
2
Location
US
Bushing requires an O.D.check under 1500lb load per SAE J835. DIA is .659, Length is 1.214
Does anybody know of a testing lab that can perform this test?
or an economical set up so that it can be done in house?

Thanks
J.
 
Sort by date Sort by votes
Where are you located?
 
Upvote 0 Downvote
Michigan,
we would like to use someone looal but its not essential
 
Upvote 0 Downvote
I would imagine that Intertek in either Livonia or Grand Rapids could do it.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

R
  • Question Question
Minimum required thickness for PAUT for process piping
Replies
2
Views
4K
Andrew ONeill
Andrew ONeill
A
  • Question Question
simulated PWHT cycles for deaerator
Replies
3
Views
4K
DekDee
DekDee
C
  • Question Question
Nondestructive Testing for Creep Detection
Replies
4
Views
3K
EdStainless
EdStainless
MCQE
  • Locked
  • Question Question
Quality Check on PED weld seamer
Replies
2
Views
304
r6155
r6155
DMRAO
  • Locked
  • Question Question
MDMT for ss 316L pipe
Replies
2
Views
1K
0707
0707

Part and Inventory Search

Sponsor

Back
Top