Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

NX4 with Windows 7 32-bit: Post Processor not working

Status
Not open for further replies.

deacons323

Aerospace
Joined
Aug 24, 2011
Messages
6
Location
US
Hi all,

I've got NX4 installed on a Windows 7 32-bit machine... when I initiate Post Processor on NX a command screen opens real quick and then closes. I'm dead in the water and hoping one of you can help. Much appreciated
 
You need to get a copy of the postino.exe from NX7.5 to replace the one in the NX4 install.

Anthony Galante
Senior Support Engineer

NX4.0.4MP10, NX5.0.0->5.0.6, NX6.0.0->NX6.0.5, NX7.0.0->NX7.0.1 & NX7.5.0.32-> NX7.5.4.4, Beta NX8.0.0.23
 
My support has expired with UG... Can I get this file from anywhere else?

Thx,
 
Are you talking about GPM, UG/Post, or Post Builder?
And what do you mean "initiate" the post processor?

Mark Rief
Product Manager
Siemens PLM
 
I'm speaking of Post Builder... When I click on it a command prompt opens up and immediately shuts down.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top