NX4 with Windows 7 32-bit: Post Processor not working

[deacons323]

Hi all,

I've got NX4 installed on a Windows 7 32-bit machine... when I initiate Post Processor on NX a command screen opens real quick and then closes. I'm dead in the water and hoping one of you can help. Much appreciated

 

[Arkance/PhoeNX]

You need to get a copy of the postino.exe from NX7.5 to replace the one in the NX4 install.

Anthony Galante
Senior Support Engineer

NX4.0.4MP10, NX5.0.0->5.0.6, NX6.0.0->NX6.0.5, NX7.0.0->NX7.0.1 & NX7.5.0.32-> NX7.5.4.4, Beta NX8.0.0.23

 

[deacons323]

My support has expired with UG... Can I get this file from anywhere else?

Thx,

 

[JohnRBaker]

Not legally, which means that NO, you cannot.

John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

http://www.plmworld.com/museum/

To an Engineer, the glass is twice as big as it needs to be.

 

[markrief]

Are you talking about GPM, UG/Post, or Post Builder?
And what do you mean "initiate" the post processor?

Mark Rief
Product Manager
Siemens PLM

 

[deacons323]

I'm speaking of Post Builder... When I click on it a command prompt opens up and immediately shuts down.